see this tiny piece....its a must have for the Awesomatix a800 series cars. it helps in keeping the bumper firmly in place after a crash as often the single screw system the stock bumper uses can loosen from this screw position after a big crash. why did Awesomatix use a single screw? because it does not stiffen up the front end of the car how a two or three screw system inevitably does. this part is especially important if you want to run your bumper without the screws that lock the bumper into the bulkheads. removing these bumper to bulkhead screws increases initial steering.

How to install:

1. ream out the stock screw hole
2. push this into place
3. i like to secure it in place with a bit of shoe goo/rubber cement